Click here to see all results
Orbis SU 63
 
new

Orbis SU 63

Made in Germany
Available at authorized resellers
Article Number: 725749

Orbis System Unit

The Orbis SU 63 system unit is used for remote “under the table” installations in conference rooms. In order to connect external components such as buttons, gooseneck microphone, headphone or loudspeaker, the system unit provides one 5-pin and two 7-pin Phoenix® connectors. By using the RJ45 sockets the system unit is connected to the control unit and to the previous system unit or microphone unit. The Orbis SU 63 system unit can be used as a chairman unit with microphone, clear and function button or as a delegate unit with one microphone button. The microphone button is used to turn the microphone on or off. By using the function button the chairman can interrupt the discussion and mute all activated delegate microphones. By using the clear button the chairman can turn off all activated delegate microphones. Depending on the configuration of the Orbis CU control unit one of the following operating modes is possible: Normal: Each participant can turn on his/her microphone until the number of open microphones is achieved. FiFo: If the selected number of open microphones (NOM) is exceeded, the microphone of the participant who turned on his/her microphone first is turned off when another participant turns on his/her microphone. Voice-controlled Activation: The microphone is turned on when the participant speaks into it, until the number of open microphones is achieved. The system units are connected in a daisy chain to the Orbis CU control unit, i.e. the first system unit is connected to the control unit, the second system unit is connected to the first, the third system unit to the second and so on. For connection standard CAT5 cables are used. Thus, one cable ensures the audio transmission, power supply and control. Connection to a control unit without redundancy A maximum of 50 system units can be connected to one line of the Orbis CU control unit, i.e. a total of 100 microphone units can be operated with one Orbis CU control unit. Connection to a control unit with redundancy A maximum of 50 system units is connected in a ring to the Orbis CU control unit, i.e. the last microphone unit is connected to the previous system unit and the control unit. The redundancy provides maximum reliablility. Should a defect in a cable occur at one side of the system unit, the system unit will not fail to operate, because it will still be supplied via the cable from the other side. The cable in question or a defect system unit as well can be replaced during operation without causing any problems with the other system units. • Shielded metal housing for remote installation • Use as chairman or delegate microphone unit possible • Phoenix® connectors for buttons, gooseneck microphone, headphone and loudspeaker • Two RJ45 sockets to connect the system unit to the control unit or another microphone unit/system unit

Contact

beyerdynamic GmbH & Co. KG
Theresienstr. 8
D-74072 Heilbronn

Phone: +49 (0)7131 - 617-400
E-mail

Downloads

Spec Sheet


For more downloads please refer to our Service section.
 

Find distributors

Country
ZIP